Did you know these Digital Repeaters are in Ozaukee County. All are Amateur Radio Format (not commercial radio systems redeployed in the ham spectrum) and include World Wide Linking on those noted.

Fusion (Yaesu marketed but open system if someone wants to produce units compatible)

D-Star (mainly Icom but 1 Kenwood radio was made, format developed by JARL and is open system)

Fusion

K9QLP/R 442.100 repeater output 447.100 repeater input. Running dual mode responds to Fusion or normal FM with CTCSS 127.3. This repeater is not linked. (sited on a high point in City of Cedarburg)

W9DHI/R 444.975 repeater output, 449.975 repeater input. Running dual mode responds to Fusion or Normal FM with CTCSS 1273. This repeater is linked to the Wires-X world wide system, normally resides on SE-WIS-NET (room number 43302). Please announce if you are changing rooms and make sure you disconnect the room when done (not just the wires-x button on radio, you must send a room disconnect command.  On HT's hold Band Key for 1 second on mobiles hold * Key on Microphone for 1 second to send room disconnect command.) (Sited on 120 foot tower on the highest point in Ozaukee County, Wide Area Coverage)

N9FRG/R 442.775 repeaterr output, 447.100 repeater input. Running dual mode responds to Fusion or Normal FM with CTCSS 1273. This repeater is linked to the Wires-X world wide system, normally resides on SE-WIS-NET (room number 43302). Please announce if you are changing rooms and make sure you disconnect the room when done (not just the wires-x button on radio, you must send a room disconnect command) (Sited at MATC north Microwave tower).

W9CQO/R  443.750 Repeater output, 448.750 repeater input.  Digital only running in Cedarburg at limited height until moved to Port Washinton site to replace the old Micor on 443.750.

D-Star

LEFROG operates a D-Star system located in Cedarburg Wisconsin.

W9FRG D 1297.500 DD

W9FRG B 442.81875 +5MHz

W9FRG C 145.225 -0.600MHz

W9FRG A 1282.15 -12.00MHz

W9FRG G Gateway system G3.10 on a Centos 7 Linux system and MonLink auto linking software as referenced below

From 00:01 to 23:59 A repeater is linked to REF019D Module (basically full time but program requires start/end time)

From 14:00 to 00:00 C repeater is linked to REF019C Module

From 14:00 to 00:00 B repeater is linked to REF019B Module

From 00:00 to 14:00 B and C are linked to REF019D Module (effectively simulcast)

(times in UTC)

Please announce if you are changing reflectors and make sure you disconnect the room when done